Plumbing/Mechanical

In accordance with the state building code, the plumbing and mechanical systems are inspected prior to covering or concealing any portion of the system. The inspection takes place after the installation of all water piping, drain, waste vent piping, fuel gas piping, HVAC ducting, range, dryer and bath exhaust ducting, furnace, boiler, water heater, unit heaters, and/or other fuel fired appliances and their venting system. (IAQ/whole house fans as applicable.) Also in accordance with the state building code, water or air pressure testing is required on all water, drain, waste and vent piping.

Show All Answers

1. Drywall/Shower Wallboard/Tile backer Inspection
2. Electrical
3. Electrical Service Panel
4. Exterior Underground Gas Line
5. Final Inspection
6. Rough Inspections
7. Framing
8. Foundation
9. Insulation Inspection
10. Interior gas lines/release
11. Lath/wrap Inspection
12. Plumbing/Mechanical
13. Roof sheathing and shear
14. Rough or precise grading
15. Shower pan (poured in place)
16. Special Inspections
17. Subfloor Insulation
18. Subsoil plumbing (or underfloor)
19. Temporary power pole
20. Underfloor and frame Inspection